Airvision2 — различия между версиями

Материал из pNp Wiki
Перейти к: навигация, поиск
м
 
(не показана 1 промежуточная версия этого же участника)
Строка 16: Строка 16:
 
* push&hold reset button, power on the camera (keep pushing the reset...);
 
* push&hold reset button, power on the camera (keep pushing the reset...);
 
* wait at least 10 seconds or till ping to 192.168.1.20 (this is camera IP in TFTP mode) is successful; release Reset button;
 
* wait at least 10 seconds or till ping to 192.168.1.20 (this is camera IP in TFTP mode) is successful; release Reset button;
* upload firmware image using tftp command: tftp 192.168.1.20; bin; put AirCam.v1.1.10874.111125.1753.bin. If you prefer you can also use any TFTP program.
+
* upload firmware image using tftp command:  
 +
tftp 192.168.1.20  
 +
bin  
 +
put AirCam.v1.1.10874.111125.1753.bin
 +
If you prefer you can also use any TFTP program.
 
* camera will update FW, *Reset the configuration to defaults* and automatically reboot.
 
* camera will update FW, *Reset the configuration to defaults* and automatically reboot.
  
 
[[Категория:Cеверное ПО]] [[Категория:ubiquiti]]
 
[[Категория:Cеверное ПО]] [[Категория:ubiquiti]]

Текущая версия на 12:21, 10 июня 2014

Airvision2

Добавляем репозитоий airvision2

echo "deb http://www.ubnt.com/downloads/airvision/apt wheezy ubiquiti" >> /root/source.list

Добавляем ключ

wget -O - http://www.ubnt.com/downloads/airvision/apt/airvision.gpg.key | apt-key add –

Обновляем список ПО и устанавливам airvision2

aptitude update && aptitude safe-upgrade
aptitude install airvision2

Заходим в систему по ссылке https://192.168.25.12:7443/

Aircam Аварийная перепрошивка камер

  • unplug the PoE cable from the camera
  • configure PC to use static IP on 192.168.1.254/255.255.255.0 network;
  • push&hold reset button, power on the camera (keep pushing the reset...);
  • wait at least 10 seconds or till ping to 192.168.1.20 (this is camera IP in TFTP mode) is successful; release Reset button;
  • upload firmware image using tftp command:
tftp 192.168.1.20 
bin 
put AirCam.v1.1.10874.111125.1753.bin

If you prefer you can also use any TFTP program.

  • camera will update FW, *Reset the configuration to defaults* and automatically reboot.